IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit Ethernet
IEEE 802.3z 1000BASE-X Gigabit Fiber
IEEE 802.3af/at Power over Ethernet
IEEE 802.3bt compliant PoE, 90W/port
IEEE 802.3x Flow Control
IEEE 802.1D STP (Spanning Tree Protocol)
IEEE 802.1w RSTP (Rapid Spanning Tree Protocol)
IEEE 802.1s MSTP (Multiple Spanning Tree Protocol)
ITU-T G.8032 / Y.1344 ERPS v1/v2(Ethernet Ring Protection Switch)
IEEE 802.1Q Virtual Local Area Network (VLAN)
IEEE 802.1p QoS/CoS Protocol for Traffic Prioritization
IEEE 802.1X Network Authentication
IEEE 802.1AB Link Layer Discovery Protocol (LLDP)
IEEE 802.3ad Link Aggregation (LACP)

Store and Forward

IEEE 802.3x flow control, back pressure flow control

IPv4/IPv6, SNMP v1/v2c/v3, LLDP, LLDP-MED, HTTP, HTTPS, SSHv2 telnet, DHCP client, DHCPv6 client, DHCP server, Port Mirror, DNS client/proxy, IP based Access Filter, ICMPv6, syslog, Time Zone /Daylight Saving, NTP client, RMON, sFlow, Loop detection, Console Port, USB configuration backup/restore, Power lost warning, relay trigger

Portbased/Single/Multi 802.1X, ACL(Port/Rate Limiters/ACE), MACbased Authentication, VLAN assignment, QoS Assignment, Private VLAN, Guest VLAN, RADIUS accounting, TACACS+, IP MAC binding, WEB/CLI authentication, Authorization (15 levels), Port Security Limit Control, ACLs for filtering/policing/port copy, IP source guard, ARP Inspection

Port/MAC/Protocol/IP Subnetbased VLAN, GARP/GVRP, Loop Guard, Link Aggregation static/LACP, BPDU guard, Error disable recovery, IGMP snooping v2/v3, MLD snooping v1/v2, IGMP filtering, IPMC throttling / filtering leave proxy, DHCP snooping, G.8032 v1/v2

DHCP option82, static routes

802.1p Queueing, Input priority mapping, Storm control for Unicast/Multicast/Broadcast, Port/Queue/ACL policer, Port egress shaper, Queue egress shaper, DiffServ (DSCP), Tag remarking, Scheduler mode

ActiPHY, PerfectReach, IEEE 802.3az EEE power management

STP/RSTP/MSTP, port trunk with LACP, ERPS v1/v2 (<50ms)

Http, Https, Telnet, SSH, CLI, TFTP, SNMP v3

PoE/PoE+ port power allocation, Power budget protection, PoE output scheduled, PoE alive check and remote reboot PD device

Dual Image Protection, PING, PING6

RFC 2674 VLAN MIB
IEEE802.1Q bridge MIB 2008
RFC 2819 RMON (group 1, 2, 3, and 9)
RFC 1213 MIB II
RFC 1215 TRAPS
RFC 4188 bridge
RFC 4292 IP forwarding table
RFC 4293 management information base for the Internet Protocol (IP)
RFC 5519 multicast group membership discovery
RFC 4668 RADIUS auth. client
RFC 4670 RADIUS accounting
RFC 3635 Ethernetlike
RFC 2863 interface group MIB using SMI v2
RFC 3636 802.3 MAU
RFC 4133 entity MIB v3
RFC 3411 SNMP management frameworks
RFC 3414 userbased security model for SNMPv3
RFC 3415 viewbased access control model for SNMP
RFC 2613 SMON – PortCopy
IEEE 802.1 MSTP
IEEE 802.1AB LLDPMIB (LLDP MIB included in a clause of the STD)
IEEE 802.3ad (LACP MIB included in a clause of the STD)
IEEE 802.1X (PAE MIB included in a clause of the STD)
TIA 1057 LLDPMED ( MIB is part of the STD)
RFC 3621 LLDPMED Power (PoE) (No specific MIB for PoE+ exists)

12Gbps

8

4095

VID 1 to 4095

4Mbits

9.6Kbytes

8K

1024

14,880pps for Ethernet port
148,800pps for Fast Ethernet port
1,488,000pps for Gigabit Ethernet port

4*10/100/1000 BASE-T with 4*bt PoE-PSE (90W/Port) Auto-Negotiation, Full/Half Duplex, Auto-MDI/MDI-X

V-, V-, V+, V+, for pin 1, 2, 3, 6; V+, V+, V-, V-, for pin 4, 5, 7, 8 *Support Modes: Mode A, Mode B, 4-Pair Mode

2*100/1000BASE-X SFP slots

Depends on SFP modules

System: Power 1, Power 2, Status (S), Master (M), Ring (R)
Ethernet ports: Speed/Link/Active
PoE: On-connected to PD devices
SFP: Link/Active
PoE Load: 50%, 70%, 90%

Provided one Mini USB B type connector for RS-232 serial signal transmission

24 VDC, 1A resistive

Dual 48-55VDC redundant power inputs * For IEEE802.3 bt application, power supply not less than 53V is recommended

1 removable 6-contact terminal block

Present (Slow-Blow Fuse)

Present

Max. 10.8W full loading

240W@48-55VDC

90W max. per PoE port

Metal, IP30 protection

51(W) x 102(H) x 90(D) mm

DIN-Rail Mounting, Wall Mounting

STD: -10°C ~ 65°C (14°F ~ 149°F)
EOT: -40°C ~ 75°C (-40°F ~ 167°F)

-40°C ~ 85°C (-40°F ~ 185°F)

5 to 95%, (non-condensing)

FCC Part 15 Subpart B Class A,
CE EN55032/EN61000-6-4 Class A

CE EN55035/EN61000-6-2:
IEC61000-4-2 (ESD), IEC61000-4-3 (RS), IEC61000-4-4 (EFT),
IEC61000-4-5 (Surge), IEC61000-4-6 (CS),
IEC61000-4-8 (Magnetic Field)

IEC60068-2-32

IEC60068-2-27

IEC60068-2-6

RoHS Compliant

UL 61010-1, UL 61010-2-201

532,087 hrs.

5 Years